Recent Posts
Featured Posts

Turn on the Haunches - Common Errors

 

 

 

    In the last blog post, we explained how to correctly execute a turn on the haunches. In this blog post, we would like to discuss common problems while performing a turn on the haunches.

     As a review, there are two ways to perform a correct turn on the haunches for Western dressage. Both are to be judged equally. The first method is to keep the inside hind leg as the pivot foot. The horse is allowed to pick up and set down the pivot foot when needed to relieve stress on the leg. The front legs will cross over one another, outside over inside. The second method, the horse will walk a small circle with the hind legs, while the front legs cross over. The size of the circle of the hind legs can be one metre in diameter.

 

 The horse is stepping back in the turn. The rider is holding too much with both reins.

 

Common faults:

  1. If the horse steps towards the in

     

    side of the turn with his inside hind leg, he is leg yielding away from the rider’s outside leg in an effort to try and avoid the bending of the joints of his hind legs. Try using less outside leg and turn the horse more from the outside upper inner thigh. You may also need more outside rein to prevent the horse from stepping in. Changing the position of the outside pushing leg may also be needed. Sometimes if the leg hasn’t been positioned back the horse will think side pass instead of turn. Moving the leg a little further back may be all that is needed. Also be aware of how your weight is placed. If your weight is too much to the outside of the turn this may push the horse sideways. Stay centered and turn from your center, like a barber shop pole.

  2. Incorrect turn, such as doing a turn on the forehand or a turn on the centre: this usually happens if the rider allows the horse’s hindquarters to swing out. The rider needs to apply more outside leg adjusted further back to block the hip from swinging. If the horse keeps swinging out with his outside hind leg, start the exercise in a corner and only ask for a quarter turn. The wall can act as a block on the outside. Again, check your position and make sure your body is turning with the horse.

  3. The horse is overbent in the neck/tilting the head: the horse should remain straight (correctly bent) throughout the turn, rather than overbent in the neck or tilting the head. If the horse overbends in the neck or pops out the outside shoulder, this is often caused by the rider pulling the horse through the turn using the inside rein, rather than using the outside aids as turning aids. The inside rein is only there to keep slight inside flexion. Pulling will result in overbend.

  4. Turn is too large: the outside rein defines the size of the turn. To make the turn tighter, bring the outside rein closer to the horse’s neck without crossing over. The outside rein may also have to hold to keep the horse from stepping too far forward. Use a deeper, holding seat to slow the steps of the horse.

  5. Backing up: if the horse steps backwards, the rider should turn his body more into the direction of the turn to engage the horse forward while applying more inside leg. The rider may also need to decrease the restraining aids. When applying the aids think outside leg to turn, then inside leg to maintain forward. Alternating between the two will keep the horse turning and forward.

  6. Loss of correct bend: the rider needs to maintain the bend with his inside leg and inside rein.

 

The rider is clearly sitting off to the right side. The horse is stepping sideways into the turn as shown by the hind legs stepping across rather than forward.

 

 The horse is overbent into the turn. In this position, it is harder for the horse to step across while maintaining clear steps behind.

 

The horse is overbent into the turn with a slight head tilt. This is caused by the rider pulling with too much inside rein. The horse is dropping his outside shoulder, making it more difficult for him to do the cross-over step.

 

The horse is counterbent due to the rider pulling too much with the outside rein.

 

 

The rider is pulling too hard with the inside rein, causing the rider to be left behind and leaning to the outside. Also, the horse’s shoulder is being left behind in the turn.

 

Keep practicing and it will get better every time. Enjoy the ride!

 

This article is the ninth in a series of articles on Western dressage and is a collaboration between Lisa Wieben (see biography below) and Birgit Stutz. The articles appear in the horse magazine SaddleUp on a monthly basis.

Share on Facebook
Share on Twitter
Please reload

Follow Us
Search By Tags
Archive